Internet of Things Based Water Quality Monitoring System


ABSTRACT
This project monitors the quality of water. Wireless Sensor integrated system for water ecosystem monitoring has been developed. pH level of normal water should be 7. Total dissolved solid value (TDS) of normal water should be 234. Temperature of normal value should be 27 degree Celsius. This project uses pH sensor, TDS sensor and temperature sensor to monitor the quality of water. Data received from sensor is given to ATmega328P micro controller. This micro controller sends this data to 16 by 2 LCD display. Also it sends this data to user over internet. By which user can monitor the quality of water over remote location through internet.

Block Diagram

Top View

Cost of Project - Rs. 15000/-


Cost with Documentation - Rs. 18000/-


Comments

Post a Comment

Popular posts from this blog

IoT Based Contact less Tachometer with Speed Control Using AVR Microcontroller and Hall Effect Sensor

Image
ABSTRACT Tachometer is device used to count the revolutions per minute of a rotating shaft. Generally tachometer makes direct contact with the rotating shaft. It will reduce the velocity of the shaft, giving faulty readings. Hence it is needed to measure the speed of rotating shaft without direct contact. This project describes a contact -less tachometer using AVR microcontroller ATmega328P and a hall affect sensor. This device can very accurately measure the rotational speed of a shaft without even touching it. This device is built on an ATmega328P microcontroller, an alpha-numeric LCD module and a Hall Effect sensor to detect the rotation of the shaft whose speed is being measured. In this project Hall Effect sensor acts as a digital counting device. It will detect any magnetic element passing in front of it and thus, will give an output pulse for each and every rotation of the shaft. These pulses are fed to microcontroller. Microcontroller counts the pulses coming from Ha
Read more

Arduino Based Solar Cell Parameter Measurement System

Image
The project is  designed  to  measures different solar cell parameters like light intensity, voltage, current and temperature by using multiple sensor data acquisition. The project uses a solar panel to monitor sunlight and Arduino board which has ATmega family microcontroller attached to it. The project requires an LDR sensor for measuring light intensity, a voltage divider to measure voltage and a temperature sensor to measure the temperature. These measurements are then displayed by the microcontroller to a LCD screen. Thus this system allows user to effectively monitor solar parameters using this system.
Read more