GSM Based Accident Alert and Identification System


When an individual riding his/her bike, meets with an accident, there is a chance that the individual may suffer from a serious injury or expire instantaneously and there is no one around to help him. Well this system is a solution to the problem. The system acts as an accident identification system that gathers and sends this vehicle information that met with an accident, and conveys it to the nearest control room.
For this the user vehicle is fixed with an RF transmitter circuit that has a vibration sensor along with microcontroller, RF encoder and also fitted with an RF transmitter. Each and every control room must have an RF receiver fitted to receive the transmission. Whenever a user vehicle meets with any accident, the vibration sensor detects and gives its output. This output is then detected by the microcontroller. Now the microcontroller sends this change detection signal to an RF transmitter. The RF transmitter now intern begins transmitting this accident data. The nearest RF transmitter reads the signal and then shows it on an LCD screen. The person monitoring the LCD screen may react to it, reach the accident location and help the needful.



Comments

Post a Comment

Popular posts from this blog

IoT Based Contact less Tachometer with Speed Control Using AVR Microcontroller and Hall Effect Sensor

Image
ABSTRACT Tachometer is device used to count the revolutions per minute of a rotating shaft. Generally tachometer makes direct contact with the rotating shaft. It will reduce the velocity of the shaft, giving faulty readings. Hence it is needed to measure the speed of rotating shaft without direct contact. This project describes a contact -less tachometer using AVR microcontroller ATmega328P and a hall affect sensor. This device can very accurately measure the rotational speed of a shaft without even touching it. This device is built on an ATmega328P microcontroller, an alpha-numeric LCD module and a Hall Effect sensor to detect the rotation of the shaft whose speed is being measured. In this project Hall Effect sensor acts as a digital counting device. It will detect any magnetic element passing in front of it and thus, will give an output pulse for each and every rotation of the shaft. These pulses are fed to microcontroller. Microcontroller counts the pulses coming from Ha
Read more

Arduino Based Solar Cell Parameter Measurement System

Image
The project is  designed  to  measures different solar cell parameters like light intensity, voltage, current and temperature by using multiple sensor data acquisition. The project uses a solar panel to monitor sunlight and Arduino board which has ATmega family microcontroller attached to it. The project requires an LDR sensor for measuring light intensity, a voltage divider to measure voltage and a temperature sensor to measure the temperature. These measurements are then displayed by the microcontroller to a LCD screen. Thus this system allows user to effectively monitor solar parameters using this system.
Read more